Product Description
Quickfinder® Clipper works on amazing Quicksensor technology that senses your pet's quick and gives you visual cues as to when it is safe and when it is not safe to begin clipping. Helps avoid cutting quick, cappilaries & nerve bundles. Includes 2 AAA batteries.
Unit is suitable for cats and/or small animals.
Features & Benefits of the Quickfinder® Clipper:
- Quickfinder® Clipper helps avoid cutting quick, cappilaries & nerve bundles
- The QuickFinder® works on most nails, even black nails.
- Quickfinder® Clipper is made from the finest quality stainless steel which will give a long-lasting, sharp cutting edge that will cut through a dog's nails effortlessly and precisely.
- State of the art non-slip handle design for maximum effectiveness and comfort
- Includes 2 AAA batteries
Note: The most important aspect of whether or not the QuickFinder® will effectively clip your pet's nails, is the hardness (density) and size of the nail. The current guillotine style QuickFinder® nail clipper does not effectively cut extremely hard (dense) or very large nails. If your pet has extremely hard or large nails, wait until the super model comes out in early 2008.
It works as follows:
Step 1: Power Up: To power on the unit and keep powered up slightly squeeze handles together until red light only is illuminated (continue to keep handles slightly squeezed together to keep power on). If all lights illuminate and remain on, there is insufficient power and batteries must be replaced. If green light stays on, turn unit off by releasing handles, wait two seconds for unit to reset and restart power up phase again. Once red light stays illuminated unit has sufficient battery power and is ready for operation.
Step 2: With unit powered up (red light on), insert nail into fixed blade hole from under side of clipper. Keep nail at 90° angle and against sensor side of the fixed blade hole. Move cutting blades toward base of nail far enough that quick in the nail will be detected for the first time. The red light will flicker and remain on. This sets the sensor to the quick in the nail. Note that the nail should continually be on the sensor side of the hole during sensing for sensing to occur.
Step 3: Maintaining power to unit, move cutting blades back towards nail tip away from nail base. The yellow light may briefly illuminate as blade and sensor approaches nail without quick. Continue moving cutting blades outward until green light illuminates indicating a safe cut. It is not safe to clip when yellow or red lights are on.
Step 4: While maintaining position and angle (90°) of clipper, squeeze handles together in firm swift motion to avoid crushing nail. It is normal for green light to turn off at end of clipping action after blade has cut through nail. If red light stays on, power off device and restart clipping process (Step 1). The QuickFinder® will automatically turn off in open position (Handles not depressed).
Made in USA
