Top Fin® Center Shelf Aquarium Stand
Pretty Handles Not Included
Pretty sturdily constructed for lower end furniture, good bracing on the bottom. But the pretty handles are not the one it comes with. I went to Home Depot and bought some more attractive handles. They should take the time to update the picture.
September 1, 2014
I purchased this stand over a year ago and liked it at first. I took my time putting it together and looked decent once assembled (minus a few edges I had to paint black). I figured this would make a good starter stand for my 75 gallon tank. The stand held up pretty good, but the overall quality is very poor. The stand is 100% laminated plywood and swells with any water drops. Also I had a small leak on a canister filter and had to trash the entire stand since it absorbed water at the bottom and the laminated finish came off. This stand is a piece of junk and I recommend spending the extra money and buying a solid "real" wood stand.
June 30, 2014
Big waste of time Very UNSATISFIED
We will make this short i didnt like the stand i bought one took it back it broke went back got anouther one that one broke....what are the chances of two broken stands and both times someone else puts them together each time and broke the same way both times if you have one of theese stands put together and u are happy with it send it to my facebook i would like to see beth swain is my name if you get it together in my thoughts it would only last for so long your fishtank would out last the stand when you buy something you want to do it right the first time and i didnt get that from this product. i made several trips to the store. eighty miles round trip each time ya i got my money back but i lost out. Good luck
March 9, 2014
Pay for what you get
Bought this stand for a 50gal tank. Set up was beyond comprehension. The material is essentially junk press-wood. So when you go to hammer in the plastic pegs to connect some of the pieces - the wood splits because the manufactured holes are too tight for the pieces they supply. The MDF wood for the top piece has misaligned holes for us as well. Two of the back holes were not properly aligned and they were about an 1 1/4 inches off. Never the less - it did not securely fit and the top did not sit on to the pegs! Due to the nature of press wood, depending on how you set up the stand on the ground, the sides can shift - gradually as you get all the pieces in, things should tighten together, but they did not come together for us. We've set up countless wooden pieces from Sweden comp and have never ran in to this amount of issues with one product.
Sad to say - we returned this and I've since watched a few videos online and have made a beautiful custom built - solid wood - stand holding our tank.
Will never buy a product meant to hold "900 lbs" that is constructed with the lowest grade of press board that is subject to mold and degrades over time or immediately after purchase.
February 25, 2014